Page 822 - 2006 HARLEY FLSTCI SERVICE MANUAL

3-35

1 2006 Softail: Engine

Figure 3-30. Aligning Circlip Piston pin circlip remover/installer Cylinder deck dowel (O-ring not shown) Figure 3-31. Pin Circlip Remover/Installer (Part No. HD-42317-A) Figure 3-32. O-ring Seal For Cylinder

d0149x3x 1. Slot 2. 3. 2 3 d0373x3x d0374x3x

The circlips could Apply a very thin film of clean H-D Apply a very thin film of clean H-D

Do not reuse piston pin circlips. result in engine damage. capture circlip in claw. recapture in claw. nose of tool. groove. Figure 3-31. seated in groove. Figure 3-32. the cylinder liner. Install new O-ring seal.
CAUTION weaken during removal causing them to break or dis- lodge during engine operation, a condition that will Install new piston pin circlip with the PISTON PIN CIR- CLIP REMOVER/INSTALLER (Part No. HD-42317-A). a. See Figure 3-30. Slide circlip down nose of tool until it contacts claw. Lightly squeeze handles of tool to Releasing pressure on handles, rotate circlip so that the end gap is centered at top of tool and then Tilt the circlip forward until the end gap contacts d. See Figure 3-31. Insert the tool (1) into the piston pin bore until claw is aligned with slot (2) in piston. Firmly push the tool into the piston pin bore until it bottoms

HOME 7. b. c. e. f. CYLINDER PART NO. HD-42322 HD-95952-1 HD-95952-33C HD-96333-51D HD-96333-103 to avoid confusion. See 1. See 2. leak.