Page 826 - 2006 HARLEY FLSTCI SERVICE MANUAL

Apply a very thin film of clean H-D 3-39 2006 Softail: Engine

NOTE If the engine was left in the chassis for service, final tighten the rear left rocker housing bolt (rear cylinder) using a torque CAUTION O-rings that are missing, distorted, pinched or otherwise damaged will result in either oil leakage or low oil pres- sure. Use of the wrong O-ring will have the same results. Since many O-rings are similar in size and appearance, always use new O-rings keeping them packaged until use 20W50 engine oil to new baffle hole O-ring (2). Install O-ring in groove around breather baffle hole in NOTE Do not confuse breather baffle hole O-ring (Part No. 11270) with the top push rod O-ring (Part No. 11293). WRONG

wrench with a 1/4 in. drive. to avoid confusion. Figure 3-42. See 9. new rocker housing. Breather channel exposed Figure 3-40. Install Rocker Housing Gasket (Rear Cylinder Shown)

Apply a small dab of LOCTITE (13.6-19.0 Nm) in the

CAUTION Even though all bolt holes (rocker housing, rocker arm support plate and breather assembly) could appear to be in alignment, the rocker housing gasket could be installed upside down. An upside down gasket will result in an open breather channel causing a major oil leak when the vehicle is started, possibly resulting in engine See Figure 3-40. Install a new rocker housing gasket on the cylinder head flange. Verify that the rocker housing gasket covers the breather channel. See Figure 3-42. With the indent (1) facing forward, place the rocker housing into position aligning the holes in the THREADLOCKER 243 (blue) to threads of six rocker hou

and/or property damage. housing with those in the gasket. Figure 3-41. the bolts to 120-168 sequence shown. Breather channel covered

HOME 6. 7. See 8. d0372x3x