Page 830 - 2006 HARLEY FLSTCI SERVICE MANUAL

3-43

Figure 3-46. Install Spring Cap Retainers 2006 Softail: Engine

d0150x3x 3.15

Verify that spring cap retainer is seated tightly
should be in approximate position against upper
Alternately tighten the two bolts to secure breather assembly to 90-120 in-lbs (10.2-13.6 See Figure 3-47. Install a new rocker cover gasket with indent facing forward on the rocker housing flange. Place the rocker cover into position aligning the holes in the CAUTION If the engine was left in the chassis for service, final tighten the three rocker cover bolts on the left side of the rear cylinder using a 3/8 in. drive torque wrench with a 7/ 16 in. flank drive “dog bone” torque adapter (Snap-On FRDH141). Failure to properly use this combination will overtighten the bolts causing distortion of the rocker Apply a
See 3.20 BREATHER ASSEMBLY for breather assembly ser-
spring cap with tip of screwdriver, use forefinger to
slide bottom edge of spring cap retainer down shaft
towards tip of screwdriver blade. As spring cap
reaches its full length of travel, spring cap retainer
d. See Figure 3-46. While simultaneously depressing

NOTE

push rod cover. against upper push rod cover. BREATHER ASSEMBLY Figure 3-45. cover with those in the gasket. See Figure 3-48. Install rocker cover bolts. the engine. 18 ft-lbs (20.3-24.4 Nm). Complete motorcycle assembly. INSTALLING ENGINE IN CHASSIS.

HOME e. vice procedures. See 1. Nm). 2. cover. 3. a. b. c. d. 4. a. b.