Page 825 - 2006 HARLEY FLSTCI SERVICE MANUAL

f2166x3x

L L
L L
4 3 3
4 Figure 3-38. Cylinder Head Bolt Torque Sequence Figure 3-39. Final Tightening For Cylinder Head Bolts

L = long bolt S = short bolt

f2166x3x S 2 1 S S 1 2 S f1583x3x

Using a grease pencil, mark a

CAUTION To ensure proper head gasket alignment, install new O- rings over cylinder ring dowels before installing the head gasket. Improper head gasket alignment will cause leaks. With the part number topside, place the head gasket over the two ring dowels in the upper flange of the cylin- Note that the word “Front” or “Rear” is cast into the top of the cylinder head to ensure proper installation. With the indent in the cooling fins facing the right side of the engine, gently slide cylinder head over the two cylinder flange ring dowels. Lower the cylinder head at an angle that closely approximates the angle of the crankcase to avoid damage to mac

CYLINDER HEAD excess oil. and/or cylinder head. Tighten the four cylinder head bolts. Figure 3-39. d. See 2006 Softail: Engine

HOME 1. der. 2. 3. 4. 5. a. b. c. e. 3-38