Page 829 - 2006 HARLEY FLSTCI SERVICE MANUAL

L L
L L d0126x3x
3 2 2 3

Breather assembly bolts (2) Breather assembly bolts (2) Alternately tighten all four rocker arm bolts 1/4 turn in the sequence shown. S = short bolt, 1.0 in. (25.4 mm) I = intermediate bolt, 1.25 in. (31.8 mm) L = long bolt, 1.75 in. (44.5 mm) Figure 3-45. Rocker Arm Torque Sequence

d0126x3x FRONT S 1 4 S REAR S 4 1 S

To rotate engine, see Place the rocker arm support plate “dog bone” torque

ROCKER ARM SUPPORT PLATE

aged bushings or a warped support plate.

lowest position) of the cam. OVERHAUL: DISASSEMBLY. Figure 3-45. bolts at this time. wrench with a 1/2 in. flank drive Tighten rocker arm support plate bolts. ments until snug. 18-22 ft-lbs (24.4-29.8 Nm). rods spin freely. lifter cover bores. spring cap retainer are free of grease and oil. 2006 Softail: Engine
CAUTION Installing the rocker arms and rotating the engine with the valve train loaded can result in bent push rods, dam- To install the rocker arm support plate, both lifters of the cylinder being serviced must be on the base circle (or ROCKER ARM SUPPORT PLATE under 3.16 TOP END assembly into the rocker housing. Loosely install the four rocker arm support plate bolts with flat washers. Place two short bolts on the left side of the engine and two long bolts on the right. Loosely install the breather assembly CAUTION If the engine was left in the chassis for service, final tighten the rocker arm support plate bolt on the rear left side of the r

HOME 1. See 2. of the rocker housing. 3. a. b. 4. can then proceed. 5. a. b. c. 3-42