Page 833 - 2006 HARLEY FLSTCI SERVICE MANUAL

s0594x3x
2

1 Figure 3-51. Retract Cam Chain Tensioner Use CAM CHAIN TENSIONER UNLOADER (Part No. HD-42313) to retract primary cam chain tensioner (6). a. See Figure 3-51. With the handle pointing toward the front of the cam support plate, place cup of tool over spring coil. Correctly positioned, the slot (3) in the tool should be adjacent to the hole in the ten- Rotate the handle of the tool in a counterclockwise direction until the hole in the tensioner is aligned with the hole in the boss of the cam support plate. Insert a retention pin (2) through the hole in the ten- sioner and into the hole in the ca

3 sprocket until loose on camshaft. cam chain and crank sprocket. blocks cast into cam support plate (1). plate from the oil pump flange.

Tensioner Retention pins Slot sioner. from the rear camshaft.

b. c.
1. 2. 3.
6. 7. 8. 9. 10. 11.

4

3 Rear cam sprocket bolt (large) and flat washer Crank sprocket bolt (small) and flat washer Figure 3-50. Cam Support Plate Assembly 1WARNING 1WARNING Use extreme caution when operating propane torch. Read the manufacturer’s instructions carefully before use. Do not direct open flame or heat towards any fuel system component. Extreme heat can cause fuel ignition and explosion. Inadequate safety precautions could Remove the rear cam sprocket bolt and flat washer (2) Remove the crank sprocket bolt and flat washer (4) from CAUTION Only use approved methods for removing rear cam bolt. Other methods of removal
Rear cam sprocket result in death or serious injury. from the rear cam sprocket (3). 2006 Softail: Engine
5 Primary cam chain tensioner

6 Crank sprocket the crank sprocket (5).
2
Link other components.
HOME F2141x3x 1 1. 2. 3. 4. 5. 6. 4. 5. 3-46