Page 823 - 2006 HARLEY FLSTCI SERVICE MANUAL

1
2

5 5
1 3
3 1

FRONT REAR Figure 3-33. Piston Ring Alignment 3 Figure 3-34. Piston Support Plate (Part No. HD-42322)

4 2 Second compression ring Top compression ring
2 4 Expander spring Bottom oil rail Top oil rail Support plate

s0235x3x 1. 2. 3. 4. 5. 1. Knobs 2. Screw 3. d0134x3x

staggered. Rotate each ring to position the gap 90 to 180
See Figure 3-33. Verify that the piston ring end gaps are
degrees from the gap in the ring above it. Locate the top

piston ring (5) gap towards the intake port. Apply clean H-D 20W50 engine oil to piston, piston rings Remove protective covers from cylinder studs. Rotate engine until piston is at top dead center. If necessary, see ROCKER ARM SUPPORT PLATE under 3.16 TOP END OVERHAUL: DISASSEMBLY. See Figure 3-34. Install the PISTON SUPPORT PLATE (Part No. HD-42322). Slide both adjustable knobs (2) on support plate (1) down away from forked end. Tighten knobs when contact is made with flats at end of slots. With the forked end of the tool pointing towards the center of the engine and the adjustable knobs facing downward, capture shank of connecting rod in fo

HOME 3. 4. and cylinder bore. 5. 6. a. b. c. See 7. a. expansion. b. pressed. c. d. e. 8. 9. 3-36