Page 711 - Med Plaza and Cancer Center
P. 711
PROPRIETARY AND CONFIDENTIAL DRAFT 28/Feb/03
Area Alarm Power-Up
Chapter 1: Introduction
b. The second LED (DA) indicates whether the Ethernet is connected
properly.
– Solid ON indicates that the Ethernet is wired properly.
– Solid OFF indicates that the wiring is bad or that the network is
not activated.
c. The third LED (DB) indicates when an Ethernet packet of information
is being sent or received. It flashes both when sending and receiving
information.
– When the network is activated, sending and receiving
information starts.
If the following shows on the display (BH) (see figure 1-54 on page 1-112),
Err
the Area Alarm Module has not been factory-programmed. Send it back to
Hill-Rom (see “Service Parts Ordering” on page 5-5).
6. If the Area Alarm is functioning properly, lock the front panel (DF).
Page 1 - 114 MedPlus TotalAlert™ Alarm Network Operation and Maintenance Manual (man291ra)
