Page 45 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 4 Frame and Carriage Assembly

Floor Mounted Frame

If the bay walls are less than 192” apart, cut both Headbeams 2” shorter than the wall spacing. Mark the
new Headbeams centerlines taking into account the machine position according to the “Position
Consideration Chart” in the previous chapter.

7) Locate two of the four head beam clamps and take them apart.
Place the non-threaded sides on top of the two L-Brackets.
Place the other half of the clamp on top of the head beam and
start the bolts. Tighten the passenger side bracket bolts down
“all the way” at the location 46-1/8” from inside of the rail to the
Headbeam centerline. Repeat the above steps on the exit end
Head Beams and Clamps. See assembled image below.

Non-Threaded

Headbeam Clamp

8) Check the rail spacing once more, tighten the driver’s side head beam clamps down completely.
If the spacing needs to be spread to 100’’, follow on with the next step; if it does not need to be
separated, skip the next step.

Direction of Travel

100” Before Carriage install Machine
92-1/4” After Carriage install Centerline Door
Centerline

9) Once the drivers side head beam clamp assemblies are completely tight, loosen the bolts until
the lock washers are no longer compressed.
10) Locate the four corner clamps and attach them to the head beam near the end. These will be
positioned when the frame is in the air.

1MANUL220 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 4-3