Page 65 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 4 Frame and Carriage Assembly

Connecting the Standard Channel Boom

3) Locate the second Wall Mount Boom Arm Assembly, the Boom Mount Clamps, the supplied 1/2-
13 x 3-1/2” fasteners, and the 1/2” stainless steel lock washers. Attach the Boom Arm to the
Boom Wall Mount as shown below.

Boom Mount Clamp

4) Locate the Boom Linkage Wear Washer, the supplied 1/2 x 5/8” stainless steel shoulder bolt, and
the 3/8-16 stainless steel Nylock™ nut. Place the wear washer in between both linkage arms and
tighten in place with the shoulder bolt and nylock nut as shown below.

Note: The Nylock™ nut should tighten to the shoulder bolt only and should not compress the
Linkage Arms. If the Linkage Arms do happen to compress together, remove the bolt and
check the length to be sure it is correct. It should have no more than 3/8” of thread length
and 5/8” of shoulder length.

1/2 x 5/8” Shoulder Bolt Boom Linkage Wear Washer (Gray
Plastic)

1MANUL220 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 4-23