Page 17 - Pivoting Wheel Stinger™ Signature® Series

PIVOTING WHEEL STINGER Signature Series

Installation

Side Manifold Installation
1) The system ships with the Side Manifold Link Weldments in place so locate the 2 rubber boots, the eight set-
screws and the 4 corresponding cable-ties shown below.

Side Manifold Link
Weldment Cable-Tie Set-Screw Rubber Boot

2) Place a cable-tie on each end of one of the boots and slide these parts over the Side Manifold Link
Weldment as shown below. Do not tighten the cable-ties yet.

Before After

3) Secure one of the Side Manifold Assemblies to the Side Manifold Link Weldment using the
supplied 3/8-16 x 1-1/4” fasteners with the corresponding lock washers as shown below. Side
Manifold Assembly shown in image right.

1MANUL587 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 15