Page 20 - Pivoting Wheel Stinger™ Signature® Series

PIVOTING WHEEL STINGER Signature Series

Installation

Side Manifold Installation
1) Locate the Side Manifold Cover and the fasteners which consist of 9 sets of one each: 1/4-20 x 1”
stainless steel fastener, 1/4” stainless steel lock washer, 1/4” stainless steel regular nut, and two
1/4” stainless steel flat washers.
There is also a set of 1/2-13 center locking nuts and 1/2“ flat washers.
2) Slide one half of the Side Manifold Cover up onto the 1/2-13 fasteners protruding from the base of
the Side Manifold Cover Support Mount. Secure with the 1/2” flat washer and the center locking
1/2-13 nut.
3) See image below for close-up of both halves in place.

a. The nuts final position should be right before the fasteners threads would start
emerging from the other side, almost flush.

b. Before moving on to the other side of the Side Manifold Cover slide the rubber
boot down over the top of the secured Side Manifold Cover, this will keep it out of
the way as you work on the other side.
4) Locate and Repeat step 22 with the next half of the Side Manifold Cover.
5) With the 9 sets of 1/4-20 fasteners, nuts, and washers mate the two halves of the Side Manifold
Cover together as shown above.
6) Tighten the clamps on the rubber boot.
7) Repeat all of the Side Manifold Installation steps on the opposite side.

18 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 1MANUL587