Page 26 - Kondor® KL 1 - E-1063 Programming and Operation Manual

®
KL1: 1063 PROGRAMMING AND OPERATION

Chapter 3 Operator Interface/Programming

Setup

Setup / Door Control

E-1063 Screen Key
· The ovals at the top of this
screen show the status of the
Entrance and Exit Doors. See
Monitor Outputs on page 1-3 of
this manual for an explanation of
the various door functions.
· Values to the right of the
YES/NO toggles are measured
in seconds.

Door Operation toggles back and forth as shown / .
Door Operation must be in AUTO for On-Board Door Controls to open or close the doors.

Temp Control: Toggles back and forth from TEMP CONTROL ON / TEMP CONTROL OFF. When TEMP CONTROL is on,
the system will hold the doors up if the outside temperature is above the set UP TEMP and the time is during wash open hours.
When the outside temperature is above the EXIT UP TEMP (Fahrenheit) the exit door will open and stay open unless it is after
hours.
When the outside temperature is above ENTER UP TEMP (Fahrenheit) the entrance door will open and stay open unless it is
after hours.
When the outside temperature falls below the AIR LOCK TEMP setting, this system will allow only one door completely open at
a time. As vehicles leave the bay and the exit door begins to close, the AIR LOCK DELAY dictates the time before the
entrance door begins to open.

Time Control: Toggles back and forth from TIME CONTROL ON / TIME CONTROL OFF. If the system is to automatically
close the wash or the doors with respect to time of day, make sure Time Control is on.
WASH OPEN and WASH CLOSED settings are in military time (hh:mm). When time of day is after WASH OPEN and before
WASH CLOSED the system is considered in the state of “During hours”. When the time of day is not between WASH OPEN
and WASH CLOSED the system is considered in the state of “After Hours”.

After WASH CLOSED time, the system will not switch to the state “After Hours” until the system has been without a vehicle in
the Loader or Wash for the CLOSED DELAY number of seconds.
CLOSE WASH AFTER HOURS / CYCLE DOORS AFTER HOURS: When toggled to CYCLE DOORS AFTER HOURS the
system will not switch to AFTER HOURS state. Therefore it will not use the WASH IN USE Output to disable the POS and it
will not disable the ENTER1 and EXIT1 extra Photo Eyes after wash hours. TIME CONTROL will over-ride HOLD DOORS UP
status from temperature control regardless of this toggle setting.
EXIT PLS and ENTER PLS: Both of these selections toggle between the following: EXIT PLS / EXIT MNT and ENTER PLS /
ENTER MNT. This is toggling between “Maintained” and “Pulsed”. When toggled to Pulsed, door outputs will remain ON for
times specified by DOWN TIME and UP TIME.
Note: Typically, systems are set to Pulsed to keep manual door control buttons operational.

DOWN TIME (in seconds) should be set long enough for the door to completely close.

UP TIME (in seconds) should be set long enough for the door to completely Open.
Enter Door Photo Eyes and Exit Door Photo Eyes will always be included in door control when the system is in AUTO. The
additional Enter Photo Eye and the additional Exit Photo Eye may be ENABLED to be included in Automatic Door Control.

3-6 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL126