Page 127 - Saber® Installation & Startup

INSTALLATION & STARTUP

Chapter 7 Pumping Station / Solution Delivery Module (SDM)

Pumping Station Connections
This section will explain all feeds to and from the Pumping Station. Settings and Startup Procedure
covered later in this document.

Low Pressure Water Valve

Pressure Relief Valve
Distribution Manifold
Main Pump Pressure Gauge

Fresh/Cold
Water Tank
Softened
Water Tank

NOTE: Motor MUST
be wired in the “Low
Voltage”
configuration.

1/4” gray poly-flow to
1/4” blue poly-flow to Pneumatic
Pneumatic Manifold 02 Manifold 03 (Hot
(Cold Water Pinch Valve) Water Pinch Valve)
Main Pump:
Cat pump #3535
Use ONLY Cat approved
replacement oil
System MUST be wired for proper
rotation!

Note: Above image shows Pumping Station with SDM mounted. The SDM can also be “Wall
Mounted”. The above image may or may not reflect your purchase. All configurations will
however be covered on the following page(s).

1MANUL290 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 7-3