Page 128 - Saber® Installation & Startup

INSTALLATION & STARTUP

Chapter 7 Pumping Station / Solution Delivery Module (SDM)

Pumping Station Connections
The Heater shown mounted on the Water Tank is optional equipment. If you have purchased
the optional wall mounted Water Heater (Super Heater), installation instructions can be found
in chapter 8 (Wall Manifold/Optional Super Heater).

Pumping Station
Distribution Manifold

SDM

Optional
Heater

Ball Check (Optional)

Reclaim Inlet Check (Optional)
Softened Water Pinch Valve V-Belt
Guard
Cold Water Pinch Valve

The above image shows the FRONT view with the SDM mounted on the Pumping Station.

CAUTION

Make sure the 25HP motor is wired for “RUN” or “Delta” not “START”. Diagram is posted on
the side of the motor.
The Triple Foam Pumps MUST use a Hyper Concentrate solution. NO Exceptions. We also
recommend the six color configuration be set at 2.5 seconds.
Plumbing Drawings and Schematics can be found in Chapter 23 of

this manual.

7-4 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL290