Page 129 - Saber® Installation & Startup

INSTALLATION & STARTUP

Chapter 7 Pumping Station / Solution Delivery Module (SDM)

Pumping Station Connections
Optional Rocker valve

Details on
Pumping Station
distribution
block shown on
Cold water Soft water next page
overflow, 1” overflow, 1”
water hose to water hose
drain to drain

Cold water low Soft water low
level sensor level sensor

Soft water Cold water
supply, 1” supply, 1”
Wire low level sensors in series FNPT FNPT

The above image shows the LEFT side of the tanks. If the SDM is The above image shows the UPPER, RIGHT side of the tanks. The
mounted directly on the Pumping Station, the shown fixtures are required 3/4” MNPT fittings are field supplied. The above image
not visible as they would be behind the SDM. They are however shows the FRONT view with the SDM mounted on the Pumping
accessible. Station.

Optional High
Pressure Wax inlet

Cold Water
Pinch Valve

The above image shows the LOWER, RIGHT view of the Pumping
Station.

CAUTION

Make sure the 25HP pump is wired for “RUN” or “Delta” not “START”.

1MANUL290 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 7-5