Page 33 - DuraTrans XD® Conveyor
P. 33
DURATRANS XD® CONVEYOR
Installation
Placing the Floor Treadle
Locate the Floor Treadle Switch Assembly, Wire Chase, and its accessory bag.
Secure the Treadle to the floor using the provided lag bolts according to the dimensions
shown below.
Feed the wire through the Wire Chase.
Secure the Wire Chase to the floor using the provided lag bolts according to the dimensions
shown below.
Connect the Treadle wires to the Belanger® Conveyor Controller System or the customer
supplied control device per the system prints.
Note: Dimensions shown for treadle placement are taken from the inside edge of the guide rail.
The treadle is shown with the wire in place. It will be necessary to install wire separately.
Overhead View
42” Dimension
taken from inside
edge of guide rail
42”
Wire Chase
Floor Treadle
12”
12” Dimension taken
Entrance Trap Door
from edge of rubber flap
Note: Floor treadle switch placement is shown in “Front Wheel Pull” configuration and with
the Correlator and Conveyor “Y” Section options.
1MANUL010 Belanger, Inc.® * PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 29
