Page 53 - TopWinder®

®
®
TopWinder

Maintenance

Hub LED Light Replacement
1) On the driver side of the Hub Assembly remove the Hub Cap Fasteners and slide the Hub Cap
all the way over to the Arm Assembly, refer to the image below.

Hub Cap
Driver Side
Arm Assembly Step 2:
Remove the plastic Clamps
from the End Plate.

LED
Assembly
Clamp (4)

Hub Assembly
(ShineMitt™ omitted for
clarity of images) End Plate

Step 1:
Remove Hub Cap Fasteners
and slide Hub toward Arm.
2) Remove the four plastic Clamps that secure the LED Wires against the End Plate.

3) Remove the End Plate Fasteners. Gently pull the End Plate away from the Hub Assembly and
disconnect the four (4) LED Wires from the Wire Harness connectors.

Step 3: Step 4:
Remove the End Plate Fasteners. Gently Pull the LED Wires out of the End
pull the End Plate away from the Hub and Plate and slide the End Plate
disconnect the LED connections. toward the Arm.

4) Pull the Wire Harness Wires out of the End Plate holes and slide the End Plate toward the Arm
Assembly.
5) Locate the Hub LED light that needs to be replaced. Remove the LED from the Hub Channel.
6) Install the new Hub LED light assembly into the channel, shown below.

LED Assembly
Hub Channel

1MANUL755 Belanger, Inc.® * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 49