Page 56 - TopWinder®

®
®
TopWinder

Maintenance

Torque Plate and Electric Motor Replacement

Note: The wiring to each Motor must be removed in order to gain access to the bottom of the
Gearbox. There you can inspect and change the flat head bolts used to mount the Torque
Plate.

DANGER

DISCONNECT MAIN POWER SUPPLY PRIOR TO SERVICING
OR MAINTAINING EQUIPMENT

Remove Motor Gearbox Assembly
1) Turn off the power and place the disconnects in the OFF position.
Note: To ensure safety we recommend following the Lock-out procedure stated above for the
main panel prior to servicing the equipment.
2) Remove the plastic Cover from the Cover Base by removing the (2) Phillips head screws.
See the image below.
Note: Removing the Cover will allow access to the Motor Gearbox mounted on the Torque
Studs.

Remove Phillip Head Screws

3) Check the voltage at the Junction Box with a multi-meter to ensure all power has been
properly removed from the circuit and no power is being supplied to the equipment.
4) Remove the Junction Box Cover to gain access to the wiring on the side of the Motor.
5) Confirm that the wiring has been tagged for terminal location if not previously identified upon
installation. Remove the nuts to release wiring from the Terminal Block. See the image
below.

52 Belanger, Inc. ®* 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL755