Page 61 - TopWinder®

®
®
TopWinder

Maintenance

Torque Plate and Electric Motor Replacement
Replacing Torque Plate Fasteners
1) Using the Loctite cleaner, clean the bottom of the Gearbox and the threaded holes.

 Allow time to air dry, in a warm environment.
 Make sure the gearbox mounting holes are clean and dry at this point. If not, repeat the
process.

Note: Once the mounting holes are cleaned and dry the Gearbox can be reassembled.
2) Place the Torque Plate and the Torque Ring back onto the Gearbox at the same position it
was in when it was removed.
Note: Confirm the position of the Torque Plate to verify correct orientation on the Gearbox.

3) Locate the supplied M8 flat head fasteners (1FSTNR-FH075).
 Carefully apply some of the supplied 271 Red Loctite on each fastener as they are
installed.

Note: Loctite should be applied lengthwise to the bottom half of the fasteners with a bead as wide
as the 3/16” nozzle tip.
4) Turn the fastener a 1/4 turn and reapply the Loctite in the same fashion.
5) Insert the flat head fasteners into the threaded mounting holes and tighten until the fastener
heads are flush with the chamfered hole within the Torque Plate.
6) Repeat steps 3 and 5 on the remaining fasteners.
 Before tightening fasteners to the proper torque, this is once again an opportunity to
verify that the Torque Plate orientation is correct on the Gearbox.

7) Using a torque wrench along with a 5 mm hex key socket, torque all eight fasteners to 26 ft-
lbs.
8) To ensure the fasteners will set appropriately, allow this assembly to cure at least 24 hours
in a warm (70 degree) environment.
Note: Loctite takes at least this length of time to cure properly.

1MANUL755 Belanger, Inc.® * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 57