Page 20 - Quad Wave Mitter®

®
QUAD WAVE MITTER

Installation

Cloth

In order to install the cloth, some disassembly is necessary. Pay attention to how the machine is taken apart.
1) Loosen the upper locking collar on the drive rack with a 3/16” hex wrench and slide it over against
the flat washer.
2) Remove the retaining pin from the upper drive arm on the Pitman arm end and remove the upper
drive arm from the Pitman arm so that the rack hangs vertically
3) Loosen outside collar using a 5/16” hex wrench.
4) Slide outside collar out away from center approximately 4”.
Front View

1-1/8” bolt
(remove for cloth installation, typical) Upper locking collar
Outside

locking collar Inside locking collar
(typical) (typical)

Shaft bearing

Inside end plate
(typical)

Outside end plate
(typical)

Cloth (typical)

16 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL633