Page 30 - Gyro Wrap™ Signature ® Series
P. 30
GYRO WRAP™ Signature ® Series
Installation
Installing Side Wheel hubs
Lower Hub Installation
2) Mount the Hub to the Shaft so that the top is 36” from the Conveyor surface on the driver side and
36” from the passenger side floor surface 60” from the center of the Conveyor (60” is the average
width of a vehicle). Do so by securing the “Spider” Clamps to the shaft while making sure the gap
between the Spiders are even as shown below.
Be sure this
gap is equal on
both sides
36”
Floor
3) Replace the Skins and tighten all fasteners. Notice the
overlapping of the tabs of the Skins as shown to the right.
Upper Hub Installation Overlapping Skin
1) Locate the 6” diameter x 42-1/4” tall Upper Hub Assembly and remove the Skins that
will reveal and allow access to the inner fasteners on the Spiders.
2) Mount the Hub to the Shaft and allow it to rest atop the Lower Hub.
3) Replace the Skins and tighten all fasteners. Be sure the overlapping of the tabs of
the Skins are as shown above.
Installing Cleaning Material
Cleaning Material Orientation
When installing single-ply cleaning material and Wash Clips, be sure the flaps are positioned
as shown in the overhead view below.
Direction of
Travel
26 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL248