Page 24 - Top Wheel Mix & Match

TOP WHEEL Mix and Match

Installation

Frame Assembly

Securing Drive Shaft and Hydraulic Motor Assembly to the Driver Side Arm
5) Using a torque wrench, tighten the 3/4-16 x 1-1/2” bolt to 120 ft/lb.

6) Remove the 3-1/2” bolt and replace the original 1” bolt and tighten it into place.

Reinstall the 1”
Remove the bolt and lock
3-1/2” bolt washer

7) Tighten the four nuts of the torque plate securely to the arm. Be sure the torque plate grommets are not
bottomed out on the arm or the four bolts. The torque plate should kind-of “float”. The images below display
tips on how to gauge the proper positions of the bolts.
Bolts should be flush on the
inside of the beams (typical)

2” from inside
edge of bolt to
outside edge of
mounting plate

20 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL749