Page 21 - Foaming Pods

FOAMING PODS

Installation

Mounting to the Top Wheel 4” Crossbeam

Before you can mount the Foaming Pods to the 4 x 4 crossbeam of the Top Wheel you must
remove and rotate the Feed Manifolds 180° (shown below). This allows the fittings to face
upward as shown in the Top Wheel image on this page.
Overview

Preparing the Feed Manifolds

Remove Manifold Block Rotate Manifold 180° Secure Manifold Back Into Place

Although the sequence above shows the Triple Foaming Pods, the same steps are
required on the Single Foaming Pods.

Top View 8” Helpful Hint
Dimensions and
placement are
recommendations.
8” Actual placement
may vary per
location and
cusomer
preference.
Moving the Pods
8” dimension applies to closer to the ends
both sides will allow for wider
coverage

Note: The above image is shown with Triple Foaming Pods. The mounting
procedure is the same for Single Pods.

1MANUL770 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 19