Page 2416 - Foton Workshop Manual - Aumark (BJ1099)

62-364 DIAGNOSIS-LIGHTING SYSTEM

Is the result normal?
Yes>To step 3.
No >Replace the bulb.

3. Check stop lamp switch

(a). Check stop lamp switch C09.

Connect
Conditions the pin by Specified
value
multimeter
Press brake 1-2 Existed
pedal

Is the inspection result normal?
Yes>To step 4.
No >Replace stop lamp switch.

4. Check the harness disconnection

(a). Ignition switch:"OFF".
(b). Disconnect stop lamp switch C09.

(c). Ignition switch: "ON", use a multimeter to
measure the voltage between No.
1 t erminal of st op lamp swit ch
C09 and the ground.
Standard resistance: (check whether there
is an open circuit)

Connect the pin by Standard value
multimeter

C09(1) - Grounding Battery volt

Page 2416