Page 1107 - Foton Workshop Manual - Tunland (AT)

DIAGNOSTICS - ASSEMBLY INSTRUMENT 04-961

(d) Use a multimeter to measure the voltage
between the pin 1 of the connector of the seat
belt alarm switch D013 on the side of
passenger and ground; the pin 1 and pin 2.

Standard voltage

Multimeter connection Standard value 04
D006 (1) - D006 (2) Battery voltage

D006 (1) - Grounding Battery voltage
D006

ftwxd041426

Check whether the result is normal?
Yes> Replace the seat belt alarm switch on the side of driver.
No > If there is no voltage of a storage battery, go to step 4. If battery voltage is not
available only between pin 1 and pin 2 of connector of seat belt alarm switch D006 on
the side of driver, repair the open circuit between pin 2 of seat belt alarm switch D006
on the side of driver and the ground D13.

4 . Check whether the signal circuit of seat belt indicating lamp on the side of driver
is of short circuit
(a) Use a multimeter to measure the voltage
between pin 6 of connector of the combination
instrument C013 and the ground.
C013
Standard voltage

16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 Multimeter connection Standard value
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17
C013 (6) -ground Battery voltage

6

ftwxd041306

Check whether the result is normal?
Yes> Repair the open circuit of signal circuit between the pin 1 of the seat belt alarm
switch D006 and the no.6 pin of connector of the combination instrument C013. 。

No> Replace the combination instrument assembly.

5 . Check whether the signal circuit of seat belt indicating lamp on the side of driver
is of short circuit
(a) Ignition Switch: OFF.

Page 1107