Page 184 - Foton Workshop Manual - Tunland (AT)

04-38 DIAGNOSTICS - ANTI-LOCK BRAKING SYSTEM (ABS)

NOTICE

• To implement the following steps, ensure that ABS/ESP is grounded properly.
• Before conducting electric diagnosis, do refer to the reference circuit diagram
and the element information.
• Before conducting measurement, check the pins of connectors for rupture,
04
looseness and rust, and ensure that the pins are contacted properly.
• If the connection is good, check the sensor signal voltage when moving the
connector and harness. If a fault occurs, the voltage display on the diagnostic
instrument will change.

1 . DTC inspection
(a) Ignition switch: OFF.
(b) Connect the diagnostic apparatus.
(c) Use the diagnostic apparatus, read the fault code.
(d) Confirm whether there is a fault code related to multiple wheel speed sensor faults ?
Is the inspection result normal?

YES>To step 2.
NO>Intermittent trouble exists.

2 . Check fuse.
(a) Ignition switch: OFF.

(b) Check fuse in the indoor fusebox:
• F26(10A)

Is the inspection result normal?
YES>To step 3.
NO>replace fuse.

3 . Check ABS/ESP power supply circuit.
(a) Ignition switch: OFF.
(b) Disconnect the battery negative cable.
(c) Disconnect connector A006 of ABS/ESP.

Page 184