Page 136 - Condition Monitor User Manual

Viewing Measurement Data

Figure 9-31 Statistics View
The ‘Graph Operations’ section of the ribbon contains additional functions that may be
useful:
• Press the ‘Clipboard’ button to copy the current graph and table (if shown) to the
clipboard; it can then be pasted into other documents.
• Press the ‘Maximize’ button to show the current graph in full-screen mode. Press
the Esc key on the keyboard to close the full-screen graph.
• Check or clear the ‘Hide Table’ checkbox to either show or hide the statistics table
underneath the graph.

9.4.8. Settings View
The Settings View is used to configure the Alerts and the selectable frequencies. To
open the Settings View, select the ‘Settings’ tab. in the ribbon.
The ribbon will display the controls for manipulating the view:

• In the ‘Sensor’ section of the ribbon select the sensor to configure.
• In the ‘Alert Levels’ section of the ribbon, set the Alert thresholds to use for that
sensor.
• The ‘Fixed Frequency Annotations’ section of the ribbon shows the two fixed
frequencies used for analysis in SMView. These are set according to the Operating
Frequency of the asset and cannot be changed.

• The ‘Selectable Frequencies’ section of the ribbon shows the two User-selectable
frequencies to analyze in SMView. By default, these are set to 3x the asset
Operating Frequency and 4x the asset Operating Frequency.

130
www.irispower.com