Page 1115 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.41

1WARNING 1WARNING Be sure to follow manufacturer's instructions when using the UltraTorch UT-100 or any other radiant heating device. Failure to follow manufacturer's instructions can cause a fire, which could result in death or serious injury. Using the UltraTorch UT-100 Robinair Heat Gun with heatshrink attachment or other suitable radiant heating device, uniformly heat the heat-shrink tubing to insulate and seal the soldered connections. Apply heat just until the meltable sealant exudes out both ends of tubing and it assumes a smooth cylindrical appearance. CAUTION Electrically connected solder outside the tubing may Inspect the melted

cause a short to ground.

HANDLEBAR SWITCH ASSEMBLIES
(00335a) 6. 7. splices.

switches include the engine start and RUN - OFF switch and
The individual switches are non- NOTE To replace or repair individual switches in either the right or left handlebar switch assemblies, see SWITCH REPAIR/ REPLACEMENT following the REMOVAL/INSTALLATION 8.43 LEFT and HANDLEBAR SWITCH. The removal and installation steps listed apply when replacing the entire switch assembly, switch The information below is useful when repairing handlebar To better access wires and avoid damaging conduit with radiant heating device, push conduit back and secure with extra 7.0 in. (177.8 mm) cable strap in kit. Strip 0.5 in. (12.7 mm) of insulation off switch wires. Twist stripped ends of switch w
The left handlebar switches include the headlamp HI - LO
switch, horn and left turn signal switch. The right handlebar

GENERAL right turn signal switch. repairable and must be replaced if they malfunction. REPAIR PROCEDURES 8.42 RIGHT HANDLEBAR SWITCH housing or handlebars. switch assemblies. coiled. of new switch assembly. one wire at a time. 2006 Softail: Electrical

HOME procedures. See 1. 2. 3. 4. 5. 8-76