Page 1117 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 1117
Throttle cable (silver insert, front hole)
5 5/32 in. (4 mm) thick cardboard insert
4
3 Figure 8-100. Throttle Cable Installation Figure 8-101. Leave Cardboard Insert in Place
2 Idle cable (gold insert, rear hole)
1 Groove in throttle grip Brass ferrule Groove
d0326x8x 1. 2. Notch 3. 4. 5. d0325x8x
Upper switch housing cable and lower switch housing. installation of the master cylinder assembly. 2006 Softail: Electrical
2 Figure 8-99. Route Cable to Upper Switch Housing NOTE To aid assembly, place a drop of light oil on the retaining rings of the crimped inserts. Always replace the retaining rings if See Figure 8-99. Route the cable (2) to the upper switch Slide the throttle control grip over the end of the right handlebar until it bottoms against the closed end. Rotate the grip so that the ferrule notches are at the top. To pre- vent binding, pull the grip back about 1/8 inch (3.2 mm). See Figure 8-100. Position lower switch housing beneath the throttle control grip. Install the brass ferrules (4) onto the cable so that the en
End fittings damaged or distorted. housing as shown.
1 1 ened. not tighten.
HOME 7958 1. 2. 3. 4. 5. 6. 7. 8. 8-78
