Page 1122 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.43 8-83

Figure 8-108. Left Handlebar Switch Housings

4 Figure 8-109. Clutch Lever Bracket 1WARNING 1WARNING Be sure that all lights and switches operate properly before operating motorcycle. Low visibility of rider can If necessary, secure wire harness conduit to handlebar using new cable strap. Position cable strap approxi- mately 4-5 in. (100-127 mm) from handlebar clamp. Cut 2006 Softail: Electrical
3
2

2 Switch housing assembly result in death or serious injury. (00316a) Test the switches for proper operation. any excess cable strap material.
3 Clutch lever bracket
Grip sleeve Ribs Grooves 1 Groove

7966 1 1. 2. 3. 7964 1. 2. Tab 3. 4. 8. 9.

LEFT HANDLEBAR SWITCH

assembly and clamp from the handlebar. lower switch housing screws. the bottom of the clutch lever bracket. using a T27 TORX drive head.

NOTE The removal and installation steps listed apply when replac- ing the entire switch assembly, switch housing or handlebars. Using a T27 TORX drive head, remove the two screws with flat washers securing the handlebar clamp to the clutch lever bracket. Remove the clutch hand lever Using a T25 TORX drive head, remove the upper and Remove the grip sleeve from the end of the handlebar if If the grip sleeve was removed, thoroughly clean handle- bar to remove all adhesive residue. Pour adhesive into new grip. Roll grip to evenly distribute adhesive on inside surfaces. Install grip on handlebar with a twisting motion. See Figure 8-108. In

REMOVAL damaged. INSTALLATION ened. not tighten. of the switch.

HOME 1. 2. 3. 1. 2. 3. 4. 5. 6. 7.