Page 1121 - 2006 HARLEY FLSTCI SERVICE MANUAL

3 Figure 8-107. Insert Cable Strap in Switch Bracket

1 Right turn signal switch
Cable strap

2 Bracket
d0330x8x 1. 2. 3.

7.0 in.

Insert tapered end of new (177.8 mm) cable strap (1) into round hole in turn signal switch bracket (2) and then feed back through using the adjacent hole. Reserve the oblong hole for the bracket NOTE Be sure that all splices are positioned above the turn signal Place the turn signal switch assembly into the housing, aligning the oblong hole in the bracket with the threaded hole in the boss. Be sure that the bracket is fully seated. Tabs on each side of bracket are captured in slots cast Start screw with lockwasher to secure bracket inside CAUTION If routed incorrectly, wires may be pinched by casting or Loop switch wires so that spliced leng

ASSEMBLY Figure 8-107. See screw. switch bracket. into switch housing. housing. handlebar resulting in switch failure. across bracket. material. stoplight switch in position. See INSTALLATION on page 8-77. the whole procedure. step 11. 2006 Softail: Electrical

HOME 1. 2. 3. 4. 5. 6. 7. 8. 9. a. b. 8-82