Page 1193 - 2006 HARLEY FLSTCI SERVICE MANUAL

The rear gap, if any,
Figure 2-15. Clutch Handgrip Rubber 1/2 Round

NOTE The brake lever control bracket should be installed and posi- tioned for rider posture with the clamp aligned to the marks on the handlebars before positioning the clutch lever control Rotate control lever brackets to match brake lever and Brake control lever clamps beginning with the top fastener to 60-80 in-lbs (6.8-9 Nm). The gap, if any, on the top should be tighter. Switch housing beginning with the bottom fastener (4-5 Nm). in-lbs

tighten fasteners: to 35-45 should be tighter.

9797a bracket. 4. a. b.

CLUTCH HANDGRIP AND If replacing clutch control lever and handgrip only, follow the safety procedures at the beginning of the procedure to remove the THROTTLE AND BRAKE CONTROLS. Remove acorn nut, lock washer, small washer and rear Remove upper and lower fasteners holding left switch housings to handlebars. Separate housings and slide left handgrip from handle- Remove fasteners and washers securing the handlebar clamp to the clutch lever bracket. Tie the clutch lever bracket and clutch cable away from chrome and paint finishes. Assemble clutch lever bracket and clamp to handlebar and install fasteners. Orient grip to rider with 1/2 round on bottom

HOME CONTROLS Removal 1. 2. view mirror. 3. 4. bars. 5. 6. Installation 1. 2. 3. a. b. c. d. e. f. 2-18