Page 1195 - 2006 HARLEY FLSTCI SERVICE MANUAL

2.10
2.9 HANDGRIPS AND HAND CON-

NOTE The turn signal wires enter the control housings through a relief grommet in the housing. The turn signal must be sup- ported throughout this procedure to prevent pulling the grom- met or the turn signal wires out of the housing. Separate clutch side and throttle and brake side switch Remove front brake lever bracket and throttle control grip. Remove clutch lever bracket and clutch side hand- grip. See 2.9 HANDGRIPS AND HAND CONTROLS. Remove tach bracket/handlebar clamp and support tach bracket/handlebar clamp away from painted and finished Support hanging turn signals and brackets. Remove handlebars, switch housings and wiring and carry

housings. See TROLS. surfaces. workbench. 8.3 HANDLEBAR WIRING.

10. 11. 12. 13. 14.

HANDLEBARS Remove seat. See 2.16 SEAT. 1WARNING 1WARNING prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Remove negative battery cable from battery. Remove instrument console. See FUEL TANK: EFI in Softail Models Service Manual. Unplug fuel pump module connector and fuel gauge Remove fuel tank fasteners, vent, fuel supply fitting and slide fuel tank back. See FUEL TANK: EFI in the Softail Models Service Manual. NOTE Note conduit routing, frame clips, and location of cable wraps for assembly. Mark wiring and connectors for reassembly. Cut cable wraps

HOME REMOVAL 1. To 2. 3. 4. connector. 5. 6. clips. 7. 8. 9. 2-20