Page 479 - 2006 HARLEY FLSTCI SERVICE MANUAL

f1360x8x-96
Push on wire end of lead to remove terminal.
Raise tang and re-install terminal. C AB Figure B-25. Packard Pull-to-Seat Terminal Connector With Locking Ear

C D

Figure B-24. Depress Tang and Extract Terminal From Mating End of Connector f1752x9x

Locate tang on latch side of chamber. Pivot end of pin to depress tang. Remove the pin and push on the wire end of the lead to extract the terminal from the mating end of the connec- tor. See C in Figure B-24. If necessary, pull back the con- duit and remove the wire seal at the back of the connector to introduce some slack in the wires. If necessary, crimp new terminals on wires. See CRIMP- ING INSTRUCTIONS at the end of this section. NOTE For wire location purposes, alpha characters are stamped Using a thin flat blade, like that on an X-Acto knife, care- fully bend the tang outward away from the terminal body. Gently pull on th

A B Assembly into the socket housings. See D in Figure B-24. place. until the latches “click.” Appendix B
HOME 5. 6. 1. 2. 3. 4. B-16