Page 483 - 2006 HARLEY FLSTCI SERVICE MANUAL

A B C

Figure B-28. Remove Socket Terminal

f2258x8x f2259x8x f2260x8x

Verify that terminal will not back out of the chamber. A
Rotate the hinged secondary lock inward until latches
terminal into wire end of connector housing until it
Carefully bend the tang outward away from the terminal
With the tang on the same side as the square shaped
opening in the mating end of the connector housing, feed
fully engage tabs on both sides of connector housing.
slight tug on the cable will confirm that it is locked.
Mate pin and socket halves of connector. Install new anchored cable strap in lower hole on left side of frame crossmember (in front of battery box). Tighten cable strap to capture conduit of both accessory connector and B+ connector approximately one inch from connector housings. See Figure B-28. Place battery in battery box, terminal side forward. 1WARNING 1WARNING Connect positive (+) battery cable first. If positive (+) cable should contact ground with negative (-) cable con- nected, the resulting sparks can cause a battery explo- sion, which could result in death or serious injury. Insert bolt through batter

Assembly body. “clicks” in place. Install seat. Appendix B

HOME 1. 2. 3. 4. 5. 6. 7. (00068a) 8. 9. 10. 11. B-20