Page 480 - 2006 HARLEY FLSTCI SERVICE MANUAL

observed moving forward slightly, then tang is
B-17
depressed. See 1 in Figure B-26. Remove safety pin.
Appendix B

NOTE Repeat steps 3 and 4 as necessary until the desired result is Push on wire end of the lead to extract the terminal from the mating end of the connector. See 2 in Figure B-26. If necessary, crimp new terminals on wires. See CRIMP- ING INSTRUCTIONS at the end of this section.

4

achieved.

6.
5.
3 Figure B-26. Extract/Install Socket Terminal at Mating End of Connector

280 METRI-PACK SERIES Depress the wireform and use a rocking motion to detach the electrical connector. Pry rubber seal from wire end of connector and move seal down wires toward conduit. Hold the connector so that the wireform is facing down, and looking into the wire end of the connector, insert the point of a safety pin between the top of the terminal and the inside chamber wall. Push safety pin completely into chamber while watching terminal on mating end of connector. When terminal is 2 Insert safety pin at wire end of connector to depress tang. Push on wire end of lead to remove terminal. Raise tang with blade of X-Acto knife. Pull on wire e

HOME Fuel Injectors Disassembly 1. 2. 3. 4. f2012x9x 1 1. 2. 3. 4.