Page 744 - 2006 HARLEY FLSTCI SERVICE MANUAL

fork stem nut (2). Be sure pin on lockwasher is engaged
Install the upper bracket (4), a new lockwasher (3) and
noticeable shake. Fork stem must turn freely from side to
Fasten the brake hose bracket to bottom bracket using
1.17 STEERING HEAD BEAR- Tighten fork stem nut (2) to 35-45 ft-lbs (47.5-61.0 Nm). 2-95 2006 Softail: Chassis
Fill neck with Harley-Davidson Special Purpose Grease
original hardware. Tighten bolt to 96-120 in-lbs (10.8-
(13) into the frame steering head and install the upper
See Figure 2-112. Insert the fork stem bracket assembly
bearing (8) and dust shield (7). Secure with the adjusting
nut (6). Tighten adjusting nut until the bearings have no
FXSTD, FXST, FXSTB Models 1. side. CAUTION Overtightening adjusting nut will cause the bearings to wear excessively leading to the need for premature bear- ing replacement. 2. in upper bracket hole. 3. 13.6 Nm). Install the headlamp assembly. 4. Install the fork sides. 5. 6. through grease fitting located in the steering head. 11WARNING 1WARNING Properly adjust fork stem bearings. Improper adjust- ments affect stability and handling, which could result in death or serious injury. (00301a) Adjust fall-away. See 7. INGS: ALL BUT FLSTSC/FXSTS. 8. Bend the lockwasher (3) tab against the nut flat. Install the fork stem cap (1). 9. FLSTSC

Insert the fork stem and bracket assembly (12) into the frame steering head. Install the Install the upper bracket (5), a new washer (3). and fork stem bolt (2). Tighten the fork stem bolt until the bearings have no noticeable shake. Fork stem must turn freely CAUTION Overtightening stem bolt will cause the bearings to wear excessively leading to the need for premature bearing Fasten the brake hose bracket to bottom bracket using original hardware. Tighten bolt to 96-120 in-lbs (10.8- Fill neck with Harley-Davidson Special Purpose Grease through grease fitting located in the steering head. 11WARNING 1WARNING Properly adjust fork stem be

INSTALLATION FLSTC, FLSTF, FLSTN, FLST Models Figure 2-111. upper bearing (7) and dust shield (6). from side to side. 13.6 Nm). Install the headlamp assembly. Install the fork sides. death or serious injury. (00301a) Adjust fall-away. See INGS: ALL BUT FLSTSC/FXSTS. Install the fork stem cap (1).

HOME See 1. 2. replacement. 3. 4. 5. 6. 7. 8. 9.