Page 739 - 2006 HARLEY FLSTCI SERVICE MANUAL
P. 739

1.19 ROCKER BEARINGS:  7  6                       5            s0224x1x













                  NOTE The threaded side of the rocker and jam nut (7) is installed If bearing races were removed, press races into rockers. See Figure 2-109. Grease rocker bearing race with a fin- ger full of grease. Place one bearing half (10) in rocker race, spherical surface against the race. Place other half of bearing on pivot stud (4), spherical Place rocker in position in rigid fork leg, with rocker fac- Install pivot stud (thin head) assembly, from bearing retainer side, through rigid fork leg, bearing and other Install thick washer (2) and acorn nut (1). Use LOCTITE THREADLOCKER 243 (blue) on acorn nut. Tighten nut Apply LOCTITE ANTI-SEIZE to threads of b






              Installation                                                                            9          10
                      inboard of the rigid fork leg.  surface towards stud head.  ing forward.  side of rocker.  to 45-50 ft-lbs (61.0-67.8 Nm).  35 in-lbs (2.8-4.0 Nm).  To adjust rockers, see   FLSTSC/FXSTS.  2




                                                    6.
                                             5.
                                        4.
                                                                                9.
                                                                     8.
                                                            7.
                         1.
                            2.
                                   3.
                                                                                                                   11                    1         Figure 2-109. Fork Rocker
                          Remove front brake caliper. See  2.20 FRONT BRAKE
                                Remove front wheel. See 2.7 FRONT WHEEL: FXSTS.

                                      11WARNING 1WARNING See Figure 2-102. Use nylon cable ties around the rigid and spring fork legs to hold them in place. If the spring fork legs are not held in place, next to the rigid fork legs, the spring pressure will snap them forward with great force, which could result in death or serious injury.  See Figure 2-102. Use cable ties to tie wrap the fork legs See Figure 2-109. Remove the spring fork rocker pivot studs (5), washers (2) and acorn nuts (1) from rocker.  Remove bearing retainer jam nuts (7). Remove acorn nuts (1) from rigid fork pivot studs. Remove rigid fork thin head pivot studs (4) from rockers and rigid fork



              FORK ROCKERS  CALIPER: FXSTS.              in place as shown.  Remove bearing retainers (6).  pivot studs (4).  Remove rockers.  Nut (2) Washer, rocker to fork leg (2)  Pivot stud, rigid fork to rocker  Bearing retainer, rigid fork Bearing retainer jam nut  Spring fork leg  Rigid fork leg  2006 Softail: Chassis









          HOME        Removal  1.  2.                  3.    4.    5.  6.  7.       8.       1.  2.  3.  4.  5.  6.  7.  8.  9.  10.  11.                        2-90
   734   735   736   737   738   739   740   741   742   743   744