Page 738 - 2006 HARLEY FLSTCI SERVICE MANUAL

s0356x2x 2-89

Acorn nut (2) Spring rod washer (2) Spring bridge Spring bridge restraint, upper (2) Rebound spring, top (2) Spring cup, rebound spring (2) Travel bumper, upper (2) Spring rod bushing (2) Travel bumper, lower (2) 6 7 3 2006 Softail: Chassis

Rebound spring, top
9 Figure 2-107. Rebound Spring: Assembly 2 Figure 2-108. Checking Spring Rod
1. 2. 3. 4. 5. 6. 7. 8. 9.
8 Spring bridge restraint, upper Exposed end of spring rod

1

1 2 3 4 5 7546 1. 2. 3.

2.20

See Figure 2-107. Oil bushing (8) and place on spring rod. Slide bushing down until it bottoms in lower rubber Install upper rubber travel bumpers (7) over spring rod Apply LOCTITE ANTI-SEIZE to top 0.5 in. (12.7 mm) of See Figure 2-108. Place upper spring restraints in posi- tion. Tighten spring restraints until the spring rods pro- trude 0.625-0.750 in. (16-19 mm) from the tops of the Be sure headlamp wire is between rebound springs See Figure 2-107. Place spring bridge (3) in position. Install washers (2) and acorn nuts (1). Tighten acorn Install front fender. See 2.33 FRONT FENDER: FXSTS. HANDLEBAR AND Install headlamp and mounting block.

travel bumpers (9). and bushing. Install rebound spring cup (6). Install rebound spring (5). Repeat steps 15 through 18 for other side. upper spring rods. 11WARNING 1WARNING Tighten both spring restraints evenly. Not having the same amount of exposed spring rod on each side could adversely affect handling. This could lead to loss of con- trol of the vehicle which could result in death or serious spring restraints. NOTES before installing upper triple clamp or spring bridge. Curved edge of spring bridge goes forward. nuts to 30-35 ft-lbs (40.7-47.5 Nm). Install front shock absorber. Install wheel. See 2.7 FRONT WHEEL: FXSTS. Install front

HOME 15. 16. 17. 18. 19. 20. injury. 21. ● ● 22. 23. 24. 25. 26. 27. 28. LAMP.