Page 813 - 2006 HARLEY FLSTCI SERVICE MANUAL

1.14

1WARNING 1WARNING After installing seat, pull upward on front of seat to be sure it is in locked position. While riding, a loose seat can shift causing loss of control, which could result in death Install new oil filter and fill oil tank to proper level. See Perform vehicle alignment. See 2.15 VEHICLE ALIGN- Check rear belt deflection and alignment. See Check rear brakes, clutch and throttle for proper opera- Check oil level after running motorcycle on side stand. See 1.4 ENGINE OIL AND FILTER.

or serious injury. (00070a) Install seat. 25. 26. 1.4 ENGINE OIL AND FILTER. Remove motorcycle from lift. 27. 28. MENT. 29. REAR BELT DEFLECTION. 30. tion. 31.

fender. Inner fender uses two bolts at the bottom and fits
Install belt guard and tighten front bolt in slot. Tighten
Install heat shields, exhaust and right floorboard. See 4.9
FXST/FLST/FLSTC/FXSTB/ FXSTS, 4.10 EXHAUST SYSTEM: FXSTD/FLSTF, 4.11 4.12 EXHAUST SYS- or Install instrument console, fuel tank, fuel gauge connec- tor, and fuel tank crossover tube. See 4.7 FUEL TANK: Install battery and connect battery cables, positive cable
the panel into position and tighten the two upper bolts.
to corresponding connector on the electrical panel. Move
Attach speedometer sensor connector from transmission
Raise the rear of the motorcycle and install rear inner
Verify that all wiring is in place and not twisted or kinked.

over a frame tab at the top. SYSTEM: EXHAUST SYSTEM: FLSTN TEM: FLSTSC as appropriate. CARBURETED. or 9.5 FUEL TANK: EFI. 1WARNING 1WARNING Connect positive (+) battery cable first. If positive (+) cable should contact ground with negative (-) cable con- nected, the resulting sparks can cause a battery explo- sion, which could result in death or serious injury. 2006 Softail: Engine

HOME 19. 20. 21. axle nut. 22. EXHAUST 23. (00068a) 24. first. 3-26