Page 845 - 2006 HARLEY FLSTCI SERVICE MANUAL

7

6
Narrow gerotor set (feed)
5 Figure 3-76. Assembling Oil Pump Figure 3-77. Oil Feed Hole
4 3

2 Wide gerotor set (scavenge) O-ring on oil pump housing Chain guide screen and O-ring 4
3 Separator plate Wave washer Outer body O-ring OIl pump housing Scavenge port O-ring Oil feed hole O-ring Rear ring dowel

2 2 2
d0217x3x 1 1. 2. 3. 4. 5. 6. 7. 1. 2. 3. 4. 1 d0138x3x O-ring in

meter reads 70 or greater) is detected, disassemble
MAC meter or greater than a 20% drop (SNAP-ON
If a leak rate higher than 11 PSI (75 kN/m 2 ) on a
Replace if missing or damaged. If the interconnect is
the engine and inspect the rubber interconnect.

fine, replace the chain guide bracket. Reinstall chain guide screen and O-ring. CAUTION O-rings that are missing, distorted, pinched or otherwise damaged will result in either oil leakage or low oil pres- sure. Use of the wrong O-ring will have the same results. Since many O-rings are similar in size and appearance, always use new O-rings keeping them packaged until use See Figure 3-76. Assemble and install oil pump. Lubri- cate parts with clean H-D 20W50 engine oil during Apply a very thin film of clean H-D 20W50 engine oil to new scavenge port stub O-ring (7). Install new O- ring on scavenge port stub of oil pump housing. Slide oil pump

HOME f. g. to avoid confusion. 17. assembly. a. b. c. d. e. f. plate (2). to avoid confusion. 3-58