Page 142 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 9 Optional “Add-On” Items

Triple Foam Option for MixStir® Pump System

If you have purchased the Triple Foam Option and are installing it onto an existing FressStyler®
machine, please follow these steps carefully.

1) For safety precautions, push in the E-Stop before you begin to work on the machine.
2) First step will be to mount the FressStyler® Tri-Foam Manifold Assembly (108973) to the carriage. Open the
exit utility cover to get to the c-channel that currently holds all of the other main water manifolds. Refer to the
pictures for the proper location and positioning of the manifold. Gather the four 1/4-20 x 2” fasteners
(1FSTNR-HH116) and the four 1/4” lock washers from the accessory box. Place a lock washer onto each
fastener and start each one into the shown holes. Tighten down completely once they are all started.

3) Located on the same carriage c-channel on the exit side is the 8-port electrical junction block. This is where
the ASCO valve will be wired to. In the accessory box is the supplied electrical cable (1ELECT-CB886).
Screw and tighten the din connector to the Asco valve and connect the other end of the cable to port #1 on
the junction block.
4) Shipped in the accessory box is 24 ft. of 6 color bundled airline (1AIRLN006). Cut the length into two 12 ft.
pieces. On the exit side of the triple foam manifold is the six 1/4” swivel Y-fittings that will feed the driver and
passenger side triple foam pods. Follow the decal that is on the c-channel for the proper color configuration.
Starting with the Y-fitting closest to the passenger side you will insert the colored airlines in order as follows.
Red, blue, green, purple, and yellow. Run the 12 ft. lengths to both sides through the hole in the carriage side
plates.

Note: As you have probably already noticed, the triple foam feed manifold is more justified to the
passenger side of the machine. Even though it is closer to the passenger side of the
machine, the 6 color bundled airline runs still need to be the same length in order to keep
the triple foam product properly balanced.

9-10 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220