Page 144 - FreesStyler® Installation and Startup

®
INSTALLATION AND STARTUP

Chapter 9 Optional “Add-On” Items

Triple Foam Option for MixStir® Pump System

11) Triple Foam Option for MixStir® Pump System Connect the supplied 3/8 x 38-1/2” clear airline from the
pneumatic valve to the feed side of the regulator.
12) Locate the supplied electrical cable (1ELECT-CB888) from the accessory box. This will run from the
pneumatic valve to the 8-port junction block. The junction block is located on the driver side carriage plate,
just to the left of the opening from the utility hole. Screw and tighten the din connector on the cable to the
pneumatic valve and connect the other end to port #1 on the junction block.
13) Purchased with the triple foam option was a set of three MixStir® pump assemblies. These will be mounted
directly to your equipment side wall, preferably just above your triple foam chemical drums. The mounting
fasteners for the pumps and the 1/2” chemical lines that will run through the boom are not provided.
14) Run your 1/2” chemical lines from the pumps through the boom and to the carriage bulkhead utility plate. Use
the 1/2” bulkheads that are in the top row of the utility plate to connect the chemical lines. Now from the
opposite side of the utility plate, run three lines from the bulkhead utility plate to the three 1/2” straight fittings
that are located on the triple foam feed manifold.

9-12 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220