Page 19 - Hydro-Hybrid™

HYDRO HYBRID™

Installation

Side Manifold Arm Assembly

1) Slide one of the Hydro Mitter Side Manifold Arm Assemblies on each of the four previously installed
Rack Connector Stud Assemblies.
2) Secure it into place using one Whip Rack Connector Thrust Bushing and one 1/4” Pin Latch on
each Stud assembly.
Note: Install the Pin Latches with the Manifold Clamping Bolt Head facing up.

3/4” Direction of
aluminum Travel
washer
(typical)
Stainless
Lock washer Plastic steel sleeve
(typical) bushing (typical)
(typical) Retaining
ring
Side Manifold Arm Assembly (typical)
• Middle and Lower Manifold Mounts
• Plastic Bushings
Middle pivot bar 3/4” Nut
(typical)
Retainer
Plastic Side manifold pin bullet
bushing arm assembly (typical)
(typical) (typical)

Lower pivot bar

1MANUL253 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 17