Page 35 - Hydro-Hybrid™

HYDRO HYBRID™

Installation

Cloth

7) Loosen the two lower bolts shown in Figure 8 to approximately 3” out.
Note: All mitter cloth is now 3” wide strips. The length will vary depending on the component in
which the cloth is to be installed.

1-1/8” bolt

Loosen these bolts
and back them out
approximately 3”

8) Mount one cloth strip onto each of the 1” pegs of the Mitter Wave aluminum end plate in the center
of the machine.
9) Push the Mitter Wave up to hold the inserted cloth piece in place. Repeat this process until all cloth
is installed.
10) Tighten the two loosened lower bolts then the 1-1/8” top bolt.
11) Slide the upper locking collar back into position.
Note: Split in collar MUST be perpendicular to the split of the shaft bearing halves.
12) Snug upper and lower locking collars tightly against both shaft bearings, and secure them into
place.
13) Repeat this process on the follower racks.
14) Replace the entrance side drive arm and all retainer pins.

1MANUL253 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 33