Page 74 - Saber® Installation & Startup

INSTALLATION & STARTUP

Chapter 6 Frame and Carriage Assembly

Frame Assembly (Wall Mounted)

Installing the Wall Mount Clamps and Carriage
1) Locate the four Wall Mount Clamps and slide them on the ends of the head beams as shown below. Do not
fully tighten them until instructed to do so.

Typical

2) Measure a distance of 101-3/4’’ up from the ground at the lowest point in the wash bay and mark a line on
the wall the length of the bay.

101-3/4”
From closest point of the floor
allowing for a slopped floor.
This will result in 106-1/2“
minimum height under the
headbeam.

6-12 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL290