Page 75 - Saber® Installation & Startup

INSTALLATION & STARTUP

Chapter 6 Frame and Carriage Assembly

Frame Assembly (Wall Mounted)

Installing the Wall Mount Clamps and Carriage
3) Using a forklift on each Crossbeam, clamp the Crossbeams firmly to the forks as shown below.

Note: Be sure to place some sort of protective material such as cardboard or cloth
between the Crossbeams and the forks or clamp to protect the powder coating
from damage.

Typical

4) Carefully raise the frame assembly up to the line you previously marked on the wall. This will set the bottom
of the rail of the Saber at 106-1/2” off of the lowest point of the floor.

5) Using a level on exit Crossbeam at its center, level the beam and secure the driver side Wall Mount Bracket
of that end to the wall.

1MANUL290 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 6-13