Page 25 - DuraTrans XD® Conveyor

DURATRANS XD® CONVEYOR

Installation

Installing the Hydraulic Drive Unit (Exit Section)

Note: The Mounting Plates on both sides of the Exit Section are identical; allowing the Drive
Unit to be installed on either side to best fit your application.
1) Remove the Sprocket from the Motor/Gearbox Assembly to allow installation of the Drive Unit.

Sprocket Breather Plug- Feeds-Facing Up
Facing Up

Helpful Hint
Drive Unit can be rotated to allow feeds
to face either up, down, left or right.

Breather Plug MUST face up.

2) Slide the gearbox onto the Exit Section Mounting Plate on the desired side (sprocket side
first).

Exit Section
Mounting
Plate (2)
Sprocket Side of Gearbox
Install from this direction
5/8-11 Locking Nuts (4)
5/8-11 x 2-1/4” Bolts (4)
3) Replace the previously removed Sprocket.
Note: Procedures to secure the Sprocket are covered on the next
page(s).

1MANUL010 Belanger, Inc.® * PO BOX 5470 *Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 21