Page 1688 - Foton Workshop Manual - Tunland (AT)

34-28 AXLE AND PROPELLER SHAFT - FRONT DIFFERENTIAL ASSEMBLY

14 . Measure the Gear Side Clearance between
Half Axle Gear and Planetary Gear
(a) Measure the gear side clearance between the
half axle gear and planetary gear with a dial
indicator.
Gear side clearance between half axle gear
and planetary gear: 0.05～0.1mm.
Maximum: 0.2mm

If the clearance exceeds the limit, check the
end clearance of the half axle gear. (Refer to
"Chapter 34. Axle & transmission shaft -
differential assembly, check & adjustment")

NOTICE

Hold the half axle gear and the planetary gear
close to the differential housing, fix any of the
two gears and measure the central point of the
other gear surface. Ensure the head of the dial
indicator is vertical to the measured gear
surface. Measure all four gears at three or more
points on each gear.

15 . Install the driven gear.
34 (a) Check for damage and wear on the driven gear surface and repair or replace it if
needed. (Refer to "Chapter 34. Axle & transmission shaft - differential assembly,
overhaul")
NOTICE

• Replace the driving and driven gears in pairs.
• Repair it for minor damage.
• And replace it in case of scratch, peeling, corrosion point, crack or overly wear.

(b) Place the driven gear in place.

NOTICE

When installing an old driven gear, clear thread
sealant and other impurities in the gear thread
hole.

Page 1688